Danly IEM Wear Products 1877 KB pdf - Anchor Danly
Danly IEM Wear Products 1877 KB pdf - Anchor Danly
Danly IEM Wear Products 1877 KB pdf - Anchor Danly
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Wear</strong> Plate<br />
Installation & Selection Guide<br />
www.danly.com<br />
Steel with Graphite Plugs & Aluminum Bronze with Graphite Plugs<br />
1. When installing and/or after cleaning, we recommend that a coat of 20 wt. oil be applied<br />
to the wear surface to help start the lubricating process.<br />
2. If grinding is necessary, grind only the back or edges of the wear plate, not the plugged<br />
side of the wear plate.<br />
3. It is not necessary to lubricate the wear plate after the initial coat of oil is applied.<br />
Plain Steel & Steel with Graphite Plugs<br />
1. It is important that wet grinding techniques be used if grinding is necessary.<br />
2. When wet grinding, do not remove more than .0002" to .0004" (0.005 to 0.010mm) at<br />
each pass.<br />
FAILURE TO COMPLY WITH THESE RECOMMENDATIONS<br />
MAY RESULT IN CRACKING OF THE WEAR PLATE<br />
Recommended Conditions for Maximum Performance<br />
1. Aluminum Bronze with graphite plugs against plain (ungrooved) steel.<br />
2. Steel with graphite plugs against plain (ungrooved) steel.<br />
3. Aluminum Bronze with graphite plugs against cast die – not recommended if load<br />
exceeds 300 psi (20 bar).<br />
4. Steel with graphite plugs against cast die – not recommended if load exceeds 200 psi<br />
(13.5 bar). Must have balanced load.<br />
1
Change language