GRAIN STIR-ATOR - David Manufacturing Co.
GRAIN STIR-ATOR - David Manufacturing Co.
GRAIN STIR-ATOR - David Manufacturing Co.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Management & Maintenance<br />
PNEG-1156 DIII Stir-Ator<br />
OPERATIONAL ADJUSTMENTS<br />
1. OUTBOARD AUGER TILT<br />
The standard DESIGN III Stir-Ator has an<br />
adjustable outboard auger tilt. When adjusting<br />
the auger toward the bin wall or if<br />
your Stir-Ator is equipped with an offset<br />
trolley, the inside wall ladder can interface<br />
with the operation of the Stir-Ator and may<br />
have to be removed or reinstalled closer to<br />
the bin wall.<br />
Photo 1A<br />
To adjust the auger tilt, loosen the 3/8" x<br />
1-1/2" carriage bolts that hold the lower and<br />
upper bearings. See Photos 1A and 1B.<br />
Loosen the 3/8" nuts on the adjustment bolt<br />
under the trolley. Adjusting this bolt will<br />
move the auger closer or farther from the<br />
wall. See Photo 1C.<br />
By moving the bearing the distance shown<br />
(See Auger Length Chart) the bottom of the<br />
auger will move the distance given. The<br />
chart is to be used as a guide only.<br />
Photo 1B<br />
Auger Length<br />
Bearing Adj. 16' 18' 20'<br />
1/8" 3-1/8 3-1/2 3-7/8<br />
1/4" 6-1/4 7 7-3/4<br />
3/8" 9-3/8 10-1/2 11-5/8<br />
Be sure to tighten the adjusting nuts and<br />
bearing bolts after the adjustment is complete.<br />
Photo 1C<br />
Trolley adjustment standard unit.<br />
40