AIR CONDITIONER (SPLIT TYPE) CLIMATISEUR ... - Klimatizace TSC

More documents

Recommendations

Info

PARTS NAME Indoor unit Discharge port flange Connects the discharge duct Earth screw Included in the electric parts box Suction port Sucks room air from here Knob Opens/Closes the suction port Air filter Removes dust or waste (Mounted in the suction port) CODE No. SET DATA SETTING TEST UNIT No. H R.C. No. TEMP. ON / OFF Outdoor unit Air inlet (Side and rear) Remote controller (Sold separately) FILTER RESET TEST TIMER SET TIME SET CL FAN SWING/FIX UNIT MODE VENT Pipes and electric wires Air outlet 3
PARTS NAME OF REMOTE CONTROLLER Display section All display items are shown in right figure for the explanation. Only selected contents are displayed in actual operation. • When turning on the leakage breaker at the first time, [SET DATA] flashes on the display part of the remote controller. While this display is flashing, the model is being automatically confirmed. Accordingly, wait for a while after [SET DATA] display has disappeared, and then use the remote controller. SET DATA H TEMP. FILTER RESET TEST SETTING TEST TIMER SET SET TIME CL UNIT No. R.C. No. FAN SWING/FIX UNIT CODE No. ON / OFF MODE VENT Display section Operation section 16 9 1 4 6 15 2 3 5 7 10 CODE No. SET DATA SETTING TEST UNIT No. R.C. No. 8 H 13 11 12 14 1 SET DATA display Displayed during setup a timer. 2 Operation mode display The selected operation mode is displayed. 3 CHECK display Displayed while the protective device works or a trouble occurs. 4 Timer time display Set time by the timer is displayed. (When a trouble occurs, the check code is displayed.) 5 Timer SETIN setup display When pushing the Timer SET button, the display of the timer is selected in order of [OFF] → [OFF] repeat OFF timer → [ON] → No display. 6 Filter display If “FILTER ” is displayed, clean the air filter. 7 UP/DOWN grille display 8 Ventilator operation display 9 Flap position display 10 SWING display Displayed during up/down movement of the flap. 11 Set up temperature display The selected set up temp. is displayed. 12 Remote controller sensor display Displayed while the sensor of the remote controller is working. 13 PRE-HEAT display Displayed when the heating operation starts or defrost operation is carried out. While this indication is displayed, the indoor fan stops or the mode changes in LOW. 14 No function display Displayed if there is no function even if the button is pushed. 15 Fan mode display The selected fan mode is displayed. (AUTO) (HIGH) (MED.) (LOW) 16 TEST run display Displayed during a test run. 4
Page 1 and 2: AIR CONDITIONER (SPLIT TYPE) CLIMAT
Page 3 and 4: ACCESSORIES (SOLD SEPARATELY) .....
Page 5: CAUTION CAUTIONS ABOUT INSTALLATION
Page 9 and 10: CORRECT USAGE When you use the air
Page 11 and 12: TIMER OPERATION A type of timer ope
Page 13 and 14: MAINTENANCE Cleaning of remote cont
Page 15 and 16: RE-INSTALLATION DANGER Ask the deal
Page 17 and 18: TROUBLES AND CAUSES (Concerning Rem

AIR CONDITIONER (SPLIT TYPE) CLIMATISEUR ... - Klimatizace TSC

Create successful ePaper yourself

Delete template?

Save as template?