STIHL 020 T - Arbtalk
STIHL 020 T - Arbtalk
STIHL 020 T - Arbtalk
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6.6 Pawl<br />
6.7 Starter Rope Guide Bush<br />
• Remove the fan housing.<br />
• Remove the spring clip from the<br />
starter post - see 6.2.<br />
Note: Do not pull the rope rotor off the<br />
starter post.<br />
The wear on the guide bush is<br />
accelerated by the starter rope being<br />
pulled sideways. The wall of the<br />
guide bush eventually wears through,<br />
becomes loose and has to be<br />
replaced.<br />
• Insert the screw spindle (1) of<br />
the installing tool through the<br />
bush from inside the housing.<br />
• Remove the rope rotor - see 6.2.<br />
• Pull the pawl out of the rope rotor.<br />
• Coat peg of new pawl with graphite<br />
grease, see 11.2, and fit it in position.<br />
• Pull starter rope out of recess (1)<br />
in rope rotor.<br />
• Undo the knot (2).<br />
• Pull starter rope out of rope rotor<br />
and guide bush.<br />
• Use a suitable tool to pry the old<br />
bush out of the fan housing.<br />
Installing the new rope bush:<br />
• Place the new bush in its seat in<br />
the fan housing.<br />
• Fit the thrust sleeve (1), tapered<br />
end first, and the hexagon nut.<br />
• Tighten down the hexagon nut<br />
until the bush is firmly seated.<br />
Note: The installing tool flares the<br />
lower end of the rope bush.<br />
• Remove the installing tool.<br />
• Thread the starter rope through<br />
the guide bush from outside and<br />
fit it on the rope rotor - see 6.3.<br />
• Refit the rope rotor - see 6.2.<br />
• Refit the fan housing.<br />
• Check that washer is fitted on<br />
starter post. Install the spring clip<br />
- see 6.2.<br />
• Refit the fan housing.<br />
<strong>STIHL</strong> <strong>020</strong> T 38