23.12.2014 Views

RealFlight G4 Manual (12.2 MB) - Knife Edge Software

RealFlight G4 Manual (12.2 MB) - Knife Edge Software

RealFlight G4 Manual (12.2 MB) - Knife Edge Software

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

R/C transmitter<br />

required<br />

No Required: 4-8<br />

channels.<br />

Computer radio<br />

not required<br />

Required: computer<br />

radio with multiple<br />

model memory.<br />

Recommended:<br />

radio with 7-12<br />

channels.<br />

Transmitter Mode: Joystick Emulation Interface<br />

The purpose of the Joystick Emulation Interface is to create a program on your own<br />

R/C transmitter to provide <strong>RealFlight</strong> with raw stick inputs. This enables <strong>RealFlight</strong> to<br />

use its own software radio to control all of the stock aircraft.<br />

It also allows you to use a single model memory, or program, on your R/C transmitter<br />

to control, without modification, all of the stock aircraft in <strong>RealFlight</strong>. We suggest that<br />

you perform the Channel Mapping and Controller Calibration procedures in this order,<br />

respectively. This will prevent you from having to re-calibrate your controller if one (or<br />

more) of the channels is not mapped correctly.<br />

Channel Mapping<br />

Before accessing the Channel Mapping… menu item, you will need to create a new<br />

program or model memory on your R/C transmitter. We suggest that you call it<br />

RFJOY or something similar.<br />

Please make sure that this new program meets the following criteria:<br />

• Is an airplane program--you do not want a heli program with all of its mixing (since<br />

all the mixing will be performed by the <strong>RealFlight</strong> software)<br />

• Does not have any mixing programmed<br />

• Has trims centered<br />

• Has ATVs set to 100%<br />

• Has dual rates and expo turned off – as these may be emulated in the <strong>RealFlight</strong><br />

software radio<br />

Prior to starting this wizard, make sure that your transmitter is attached to the<br />

InterLink Elite controller and that the controller is on. Click the Controller menu<br />

followed by the Select Controller menu item. There will be a momentary pause while<br />

<strong>RealFlight</strong> detects the R/C transmitter. Next, click InterLink Elite Transmitter X<br />

145

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!