SUPERLITE HELMET REMOVAL12.pdf - Association of Diving ...

More documents

Recommendations

Info

The following procedures only address the referenced models of SuperLite helmets and were developed in cooperation with Diving Systems International and may not apply to other helmet types. 8
Manufacturers of specific helmets should be contacted for safe removal procedures of their helmets in suspected neck (cervical spine [cspine]) injuries. Likewise, manufacturers of helmets other than those identified below are encouraged to ensure that a procedure is developed and promulgated to permit safe removal in emergency circumstances and, consistent with the time lines necessary to place an injured diver in a recompression chamber. 9
Page 1 and 2: ASSOCIATION OF DIVING CONTRACTORS I
Page 3 and 4: EMERGENCY REMOVAL OF DIVING SYSTEMS
Page 5 and 6: Standard emergency medical protocol
Page 7: These procedures also furnish a rem
Page 11 and 12: CAUTION These procedures only addre
Page 13 and 14: The primary consideration should be
Page 15 and 16: 1. A minimum of two properly traine
Page 17 and 18: 4. The dive team member who initial
Page 19 and 20: Have heavy bandage scissors or para
Page 21 and 22: Address "A B C s" of first aid. AIR
Page 23 and 24: DIVER IN “RECOVERY” POSITION No
Page 25 and 26: CUT HARNESS CLEAR 25
Page 27 and 28: "Crack" Steady Flow (Side Block) va
Page 29 and 30: The dive team member holding the di
Page 31 and 32: The second dive team member opens t
Page 33 and 34: CLEAR REAR HINGE TAB 33
Page 35 and 36: The second dive team member then ro
Page 37 and 38: The helmet is then placed in front
Page 39 and 40: The second dive team member (using
Page 41 and 42: The second dive team member then li
Page 43 and 44: Reposition the diver on his/her bac
Page 45 and 46: Using shears, cut the suit neck dam
Page 47 and 48: MODEL 27A/B, 17C & 17K HELMET REMOV
Page 49 and 50: Have heavy bandage scissors or para
Page 51 and 52: Address "A B C s" of first aid. AIR
Page 53 and 54: DIVER IN “RECOVERY” POSITION No
Page 55 and 56: Release the umbilical from the dive
Page 57 and 58: OPEN (Crack) AIR SUPPLY VALVE 57
Page 59 and 60:
MAINTAINING HEAD/C-SPINE POSITION 5
Page 61 and 62:
RELEASE (2) PULL-PINS 61
Page 63 and 64:
OVERPRESSURIZE HELMET TO RELEASE NE
Page 65 and 66:
The dive team member maintaining th
Page 67 and 68:
ROLL HELMET FORWARD then BACK 67
Page 69 and 70:
The helmet is then placed in front
Page 71 and 72:
Release chin strap at the neck ring
Page 73 and 74:
CUTTING NECK DAM 73
Page 75 and 76:
Move the bailout cylinder, weight b
Page 77 and 78:
POSITION DIVER FOR IMMOBILIZATION &
Page 79 and 80:
CUT SUIT AS NECESSARY 79
show all

SUPERLITE HELMET REMOVAL12.pdf - Association of Diving ...

Create successful ePaper yourself

Delete template?

Save as template?