Urma - Command Tooling Systems

Finish Boring Insert
Pocket Features & Straight
Shank Toolholders
Finish Boring Insert Pockets
The standard Urma insert pocket is designed to utilize CCMT style inserts or 7˚ relief inserts. But, over time, Urma has determined that there can be
advantages to using an insert with an 11˚ relief. It is for this reason that new products have been introduced using a new insert pocket design.
The new design is the W/C part number. The W/C pocket is made to support both a 7˚ as well as an 11˚ relief insert. Most insert pockets are milled with a
particular draft to determine the angle that the cartridge will support.
The W/C pocket has both a 7˚ and 11˚ draft (see diagram below), so it can rigidly accommodate any CPMT, CPGT, or CCGT style insert.
.012"
11°
7°
HW/C06..
W/C20..
If your work material is constantly changing, the advantage
of using a multiple of insert geometries is immeasurable. This
freedom allows you the ability to always have the best cutting
edge geometry or grade available for all materials you may
encounter.
Straight Shank Toolholders for Boring Tools on Lathes
D
Coolant
Through
5.000
A
Urma boring tools can be very effective on applications where the part is
turning and the boring tool is stationary.
The toolholders listed below have a Beta Modul® for the application of
various MicroMax, VersaMax, or IntraMax tooling on machines that
require a straight shank.
All tools are coolant through.
Variations of the standard designs listed below to suit other machine
requirements are available upon request.
L
A L D C
32 6.575 1.575 1.5 1.259 3.0
40 6.772 1.772 1.5 1.653 4.5
63 7.362 2.362 1.5 2.480 5.0
63 7.362 2.362 2.0 2.480 6.0
COD
(NOTE: Double Cutter Roughing Head Sold Separately)
800.328.2197800.555.7694support@commandtool.comwww.commandtool.com
6