TENNANT 7100 SCRUBBER DRYER OPERATOR MANUAL - Clemas

OPERATION
CIRCUIT BREAKERS
Circuit breakers are resetable electrical circuit
protection devices designed to stop the flow of
current in the event of a circuit overload. Once a
circuit breaker is tripped, reset it manually by
pressing the reset button after the breaker has
cooled down.
If the overload that caused the circuit breaker to
trip is still present, the circuit breaker will continue
to stop current flow until the problem is corrected.
The circuit breakers are located on the operator
console.
Circuit
Breaker Rating Circuit Protected
CB1 5A Machine power
CB2 10 A Lights
CB3 10 A Horn
CB4 10 A Power wand/
Back up alarm
CB5 10 A Control panel
CB6 20 A Vacuum Fan (single)
CB6 40 A Vacuum Fan (dual)
CB7 10 A ESt System (option)
FaSTt System (option)
CB8 25 A Left brush motor
CB9 25 A Right brush motor
The chart below shows the circuit breakers and
the electrical components they protect.
FUSE
The fuse is a one-time protection device designed
to stop the flow of current in the event of a circuit
overload.
NOTE: Always replace the fuse with a fuse of the
same amperage.
The fuse is located behind the operator console.
Access the fuse by lowering the operator console.
Fuse Rating Circuit Protected
FU-1 40 A Propelling
7100 330699 (3 -04)
17