Invento IFT Drives - Systemair
Invento IFT Drives - Systemair
Invento IFT Drives - Systemair
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Invento</strong> EC Drive<br />
DOMEL<br />
1.0 Safety<br />
1.1 General warning<br />
The voltage of the EC drive is dangerous whenever the drive is connected to the AC line.<br />
Incorrect installation of the motor or drive may cause damage to the equipment, serious<br />
injury or death. Comply with the safety instructions in this manual as well as local and<br />
national rules and safety regulations.<br />
1.2 Personal safety<br />
1. Disconnect the EC drive from the AC line if repair work is to be carried out. Wait 4 minutes to allow for electrical<br />
discharge before disconnecting motor and AC lines.<br />
2. The [ON / OFF] input on the user interface panel of the EC drive does not disconnect the drive from the AC line. Do not<br />
use it as a safety switch.<br />
3. Do not remove the terminal lines for the motor and AC line supply while the EC drive is connected to the AC line.<br />
Ensure that the AC line supply has been disconnected and then wait 4 minutes before removing motor and AC lines.<br />
4. The motor can be started by means of digital commands, bus commands, references or a local start command<br />
whenever the drive is connected to the AC line. Therefore, an unintended start may occur anytime power is applied.<br />
Never service the drive or equipment when power is applied to the drive.<br />
5. Before installing and operating this EC-controller please read this instruction carefully!<br />
Warning:<br />
It can be extremely dangerous to touch the electrical parts even when the<br />
mains supply has been disconnected. Also ensure that other voltage<br />
inputs are disconnected from load sharing through the DC bus. Wait at<br />
least 4 minutes after the input power has been removed before servicing<br />
the drive.<br />
DOMEL – <strong>Invento</strong> <strong>IFT</strong> EC <strong>Drives</strong> – Operating instruction<br />
Version: V3.0, June2013<br />
4