Instruments Brochure - WoodBeam

Test tools
VoltPointer
Article number: 626 000 663
Voltage detector
The VoltPointer has equal functions to the VoltSafe; it is a
voltage detector ánd non-voltage indicator. The detector is
always activated and will automatically give a (red) optical and
an acoustic signal upon the presence of voltage.
By activating the on/off switch, the correct operation of the
detector is checked (selftest). A single beep will sound and the
probe tip will illuminate shortly. Both the pcb as well as the
battery power are tested. The proper functioning of the unit is
proved and a green LED is given for ~ 15 sec. Upon detection of
voltage the VoltSafe will indicate both optical as acoustic. Since its
functionality was tested, no indication of the VoltSafe means no
detection of voltage; non-voltage detection.
In the tip of the VoltPointer, a bright LED is positioned that can
be switched on manually and used as a (small) flashlight/torch.
This makes the VoltPointer very suitable for use in poorly lit
locations such as switch boards, distribution boxes etc.
Features
•
•
•
•
•
Non Voltage detection
Optical and acoustical signal when voltage is detected
Self-test by on/off switch
100 – 1000V AC
Flashlight/torch
Including
IP
+ Batteries
+ Manual
Specifications
Function
Voltage detection
Range
100 – 1000 Volt AC
Specifications
Supply
IP-Protection
Overvoltage category
Drop proof
2x AAA, 1.5V battery
IP64
CAT IV / 600V - CAT III / 1000 V
4 ft.
Acc. to Standard EN 61010-1
Dimensions
Weight
128 x 28 x 16 mm.
± 60 gram
16
www.nieaf-smitt.nl