Vantage Modulating - Roberts Gordon
Vantage Modulating - Roberts Gordon
Vantage Modulating - Roberts Gordon
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SECTION 10: WIRING<br />
10.2.2 Satellite Heater Configuration<br />
Satellite heater configuration is set by positioning of<br />
jumpers on pin block J10 located on the control board<br />
inside the heater compartment, See Page 41, Figure<br />
24. Jumper position on J10, shown on Page 41,<br />
Figure 24 will configure heater as a satellite heater.<br />
(The jumper position for satellite is the same as the<br />
jumper position of a central heater using a zone<br />
sensor). Jumper on J9 may be left alone.<br />
FIGURE 24: Satellite Heater Jumper Setting<br />
41 of 71