Polyurethane Timing Belts - BRECOflex CO., LLC

POLYURETHANE TIMING BELTS
STOCK PULLEYS
The BRECOflex CO., L.L.C. pulley stocking program includes the pulley configurations listed below. Stock pulley
material is aluminum with zinc plated steel flanges. Select the standard pilot bore or incorporate custom
modifications, some of which are listed at the bottom and shown on the opposite page. Modified stock
pulleys, in small quantities, are usually delivered in one week.
teeth range stock pulleys
Pitch (not all # of available
teeth available for belt widths
from to (mm)
T2.5 10 60 6,10
T5 10 60 10, 16, 25
T10 12 60 16, 25, 32, 50
AT3 15 72 6, 10, 16
AT5 15 72 10, 16, 25, 32
AT10 15 60 25, 32, 50
ATN10 25 60 25, 50
ATN12.7 20 32 25, 50, 75, 100
ATL5 25 72 10, 16, 25, 32
teeth range stock pulleys
Pitch (not all # of available
teeth available for belt widths
from to (mm)
XL 10 40 12.7, 25.4
L 10 25 25.4, 50.8
H 14 40 25.4, 38.1, 50.8, 76.2
TK5 K6 25 48 50
TK10 K13 20 48 50, 100
ATK10 K6 20 60 50, 100
ATK10 K13 20 60 50, 100
HK13 20 36 50.8, 101.6
BAT10 20 60 32, 50
ATL10 25 60 25, 32, 50
All stock timing belt pulleys can be customized and modified to specific requirements. Complex
machining and intricate details can be realized. These modifications can include but are not limited
to the following:
• add/remove flanges • reduce pulley width • bolt holes
• finish bore • counter bores • snap ring grooves
• remove or change hub • set screws • lightening holes
• cut key seat • taper bores • self-tracking groove
Please provide your requirements to BRECOflex CO., L.L.C. Engineering Department.
170
Toll Free: 1-888-463-1400 • Fax: 732-542-6725 • Website: www.brecoflex.com