CC2540 Mini Development Kit User's Guide (Rev. A) - myGolfBuddy
CC2540 Mini Development Kit User's Guide (Rev. A) - myGolfBuddy
CC2540 Mini Development Kit User's Guide (Rev. A) - myGolfBuddy
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Figure 36<br />
Page 25 of 29<br />
SWRU270<br />
The value shown must be “0008” or higher; otherwise the debugger will not recognize the <strong>CC2540</strong>. If the<br />
firmware is “0007” or less, the firmware will need to be updated.<br />
To update the firmware, click the “…” button next to the “Flash image” text box, and select the following<br />
file:<br />
C:\Program Files\Texas Instruments\Extras\ccdebugger\cebal_fw_srf05dbg.hex<br />
With the “Erase, program and verify” selected under “Actions”, click the “Perform actions” button. This<br />
will update the CC Debugger firmware to version “0013”.<br />
Figure 37<br />
The process will take around 10 seconds. Once complete the “EB firmware rev” value should change to<br />
“0013”. The debugger should now be able to recognize the <strong>CC2540</strong>.<br />
5.3.2 Reading or Writing a Hex File to the <strong>CC2540</strong><br />
To read or write a hex file to the <strong>CC2540</strong>, select the “System-on-Chip” tab. The connected <strong>CC2540</strong> should<br />
be detected and show up in the list of devices. Under “Flash image” select the desired hex file that you