Celestron Nexstar GPS 11 Removal and Replacement of ... - DD1US

ePAPER READ

DOWNLOAD ePAPER

dd1us.de

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

START NOW

Take the 4, #1 phillips head screws out of the position plates and remove the plates

Remove the nut from the shaft. You will have to hold the bottom of the base as you turn the

nut.

5/10

Heating of the hand-controller of the NexStar N5i/N8i ... - DD1US

Elektrische Fokussierung mit Infrarotsteuerung: - DD1US

Dressler ARA-2000 active antenna - DD1US

Tips, hints and pending problems for Celestron Nexstar ... - DD1US

AOR AR5000 accessory connectors 1v0 - DD1US

Modifikation des J.I.L. RF-1030 KW Konverters mit ... - DD1US

Celestron Spare Parts 2010-09-11 - DD1US

The Ã¢Â€ÂžElectronic AntennaÃ¢Â€Âœ Ã¢Â€Â“ a short analysis - DD1US

Beschreibung eines 2m Bandpassfilters TRIO Modell BPF-2 - DD1US

Analyse des Empfangssystems von J.I.L. incl. SX-400, RF ... - DD1US

Radio Direction Finder DDF6001 from Doppler Systems - DD1US

Analyse des SWR & Power Meters K-PO SX-144/430 - DD1US

Once you have had a look. Disconnect the two wire connector from the position plates. Then gently pull on the wires going into the fork arm to take up the slack and give you a little room to set the BTC into a better position as shown. View from right with HC in back. 4/10

Take the 4, #1 phillips head screws out of the position plates and remove the plates Remove the nut from the shaft. You will have to hold the bottom of the base as you turn the nut. 5/10

Page 1 and 2: Celestron Nexstar GPS 11 Removal an
Page 3: On mine I noticed that the factory
Page 7 and 8: Once you have removed the nut the u
Page 9 and 10: Remove the 3 nuts from the tension

Celestron Nexstar GPS 11 Removal and Replacement of ... - DD1US

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?