S-XPF VOL3.indd - OSG

INDEX
TOOLS
New Sizes
New Sizes
NEW
NEW
NEW
NEW
New Sizes
NEW
NEW
NEW
NEW
NAME
THREAD
TYPE RANGE PAGE
M
S-XPF M 3 ~ M 30 4
M
OIL-S-XPF M 6 ~ M 45 5
M
S-XPF-6GX M 3 ~ M 16 6
M
S-XPF-7GX M 3 ~ M 16 7
M
S-XPF-P M 3 ~ M 20 8
M
S-SC-XPF M 3 ~ M 16 9
MF
S-XPF M 8 ~ M 20 10
MF
OIL-S-XPF M 8 ~ M 20 11
MF
S-XPF-P M 8 ~ M 20 12
UNC
S-XPF N° 5 ~ 1" 13
UNF
S-XPF N° 6 ~ 1" 14
G
S-XPF-SPT G 1/8 ~ G 1/2 15
DIN 371
1. Only M6 shanks have a male center.
2. The proper drill hole size may change due to work material. Use the recommended drill hole
size as a benchmark.
3. As the hole diameter may vary by behavior of plasticity depending on the material, hardness
and shapes of workpiece, the hole diameter should be determined through trial tapping prior to
final machining.
4. The drill hole size is for a 6H internal thread.
5. TAP Limit does not guarantee thread limit for the internal thread after tapping.
C0.%
Cu
0.5C0.4%
BS
ppcos weuge ppco ppcos ppo ppo pccoes
0.45%
BsC
SCM
PB
55C
Al
545C
AC,ADC
DIN 374 DIN 376
455C 1. The proper 5C drill hole size may SUSchange due SKD to work material. SC Use the recommended GG drill GGGhole
size as a benchmark.
2. As the hole diameter may vary by behavior of plasticity depending on the material, hardness
and shapes of workpiece, the hole diameter should be determined through trial tapping prior
to final machining.
3. MC The drill hole ZDC size is for a 6H internal Ti thread. Ni
Plast.
Vinyl
4. TAP Limit does not guarantee thread limit for the internal thread after tapping.
2
OSG Europe: www.osgeurope.com