ZF S5-325 service manual - The Car Nut

- 26 -
can also be screwed into the thread of the intermediate plate.
Secure end housing with screws (109 and 112) and the 2 hexagon
nuts (105). Place spring washers (106) below the screws (112) and
below the nuts (105). The two screws (109) are secured with tab
washers (108). Push output flange (443) on the splined section of
the main shaft and secure with hexagon screw (445) and tab washer.
Fit speedometer drive and secure with hexagon screw (809) and tab
washer (808). Place the two sliding pieces (635) into the bores of
the 5th speed selector bracket (634).
Fig. 31.
Guide the pre-assembled selector bracket into the 5th gear sliding
sleeve (402) so that the selector finger engages the 5th gear
selector bar (Fig. 31) and the swivel bolt (116) with the seal
rings (117) can be screwed in. Check selector fork for ease of
operation.