How Do Solar Panel Work? A solar panel is a ... - Digital Consummate

4. the battery is installed
1).When the battery box under the control of light using light have to take to prevent the damaged
control box;.
2). Between the battery cable bolt pressure must be at the terminal on the battery and the use of
copper pad to enhance the conductivity.
3). Output line connected to the battery under any circumstances after the ban on short then, to avoid
damage to the battery.
4).The output line of batteries and the controller poles must be linked through the PVC pipe threading.
5). The above is completed, check the controller side of the wiring to prevent short circuit. Well after
the normal clearance of the door control box.
5. lamp installation
1). For each part of the fixed components: solar panels at solar panels fixed on solar Panel Mounting,
lamp holder fixed to the pick arm, and then pick stent arm and fixed to the main bar, and cable into
control box to wear (battery box).
2) Lifting the poles before to check whether the strong parts of fasteners, lamp installation is correct,
whether it is normal for light work. And in the simple normal debugging system; release controller
cable on solar panels, light work; cable connected to solar panels, lights out; controllers
simultaneously on careful observation of changes in the indicator; all belong to the normal before
lifting installation.
3). Lifting the main poles, the attention to safety precautions; screws fastening the absolute
good,components angle towards the sun such as the wrong point of view, end up required to adjust its
direction towards south.
4) The battery into the battery boxes will be in accordance with the technical requirements of
connecting lines connected to the controller; to access the battery, making the load, and then take the
solar panels; cable operator must pay attention to when the connection with the controller on each of
the terminals marked Then should not mistake, positive and negative poles of the collision should not,
should not take anti-; otherwise, the controller will be damaged.
5) Normal debugging system; release controller cable on solar panels, lights; cable connected to solar
panels, lights out; controllers simultaneously on careful observation of changes in the indicator; all
belong to the normal, well before closure control box.
6. Solar street light Notes
Star solar responsible to provide users with the installation of street light and solar power to provide
technical services and advice. If the user to install light at the ground, paying attention to the matter
as follows:
1, Solar street lights to solar radiation energy, radiation in the optical components on the battery if
sufficient sun lamps light a direct impact on results, so the installation of light at select locations, the
battery components at any time be able to have exposure to sunlight, and shelter materials, such as
non-leaves.