Coilover Kit MAZDASPEED.pdf - RX8Club.com
Coilover Kit MAZDASPEED.pdf - RX8Club.com
Coilover Kit MAZDASPEED.pdf - RX8Club.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Mazdaspeed RX8 <strong>Coilover</strong> <strong>Kit</strong> Installation Instructions<br />
(10) Helper Spring<br />
(11) Spacer – Spring (same as rear)<br />
(12) Front Spring – 800.250.0400<br />
(13) Spacer – Bump Stop<br />
(14) Bump Stop<br />
(15) Spring Isolator (same as upper)<br />
(16) Pre-Load Collar<br />
(17) Collar Lock<br />
(18) Front Damper<br />
1c<br />
FRONT DAMPER/SPRING INSTALLATION<br />
WARNING: Do not use an impact wrench on the top nut<br />
10. Re-assemble in reverse order, but only snug (do not apply torque) either of bolts B or nut E (Figure A) until<br />
the vehicle is on the ground. Failing to do so could result in pre-mature failure of the rubber bushings, and<br />
will force the vehicle to sit higher. All torques, with the exceptions to the ones below, are shown in Figure<br />
A.<br />
Torque for Stabilizer bar nut is 43.1-60.8 N-m<br />
Torque for front-upper mount-to-tower nuts is 29.4-39.8 N-m<br />
RX-8 - Revision B Page 4
Change language