WM-120P/S HYDRAULIC MIXER - Southern Tool
WM-120P/S HYDRAULIC MIXER - Southern Tool
WM-120P/S HYDRAULIC MIXER - Southern Tool
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>WM</strong>-<strong>120P</strong>/S <strong>HYDRAULIC</strong> <strong>MIXER</strong> — TROUBLESHOOTING (ENGINE/<strong>MIXER</strong>)<br />
T ABLE 3. ENGINE TROUBLESHOOTING (CONTINUED))<br />
SYMPTOM<br />
POSSIBLE<br />
PROBLEM<br />
SOLUTION<br />
Insufficient power output<br />
"compression" and overheats<br />
Burns to much fuel<br />
Exhaust color is continiously<br />
"WHITE"<br />
M alfunction in cooling fan? Check or replace cooling fan.<br />
A ir in-take filter clogged? Clean or replace air in-take filter.<br />
Over accumulation of exhaust<br />
products?<br />
Clean and check valves.<br />
Check muffler, replace if necessary.<br />
W rong spark plug?<br />
Replace spark plug with manufactures suggested type spark plug.<br />
Lubricating<br />
viscosity?<br />
Worn<br />
rings?<br />
oil is wrong<br />
Replace lubricating oil with correct viscosity.<br />
Replace rings<br />
A ir cleanner clogged?<br />
Clean or replace air cleaner.<br />
Exhaust color is continiously<br />
"BLACK"<br />
Choke valve has not been set<br />
to the correct position?<br />
Carburetor defective, seal on<br />
carburetor broken?<br />
Poor carburetor adjustment<br />
"engine runs too rich?<br />
Adjust choke valve to the correct position.<br />
Replace carburetor or seal.<br />
Adjust carburetor.<br />
SYMPTOM<br />
TABLE 4. <strong>MIXER</strong> TROUBLESHOOTING<br />
POSSIBLE<br />
PROBLEM<br />
SOLUTION<br />
Paddle blades will not rotate.<br />
B roken connector pin?<br />
Replace connector pin. Use P/N 3215 when ordering.<br />
E xcessive weight/material in drum? Remove some of the material in the drum.<br />
Material<br />
ends.<br />
leaking from drum<br />
Drum difficult to discharge (tilt).<br />
Worn or defective paddle shaft<br />
seals?<br />
Malfunction in air-cleaner system,<br />
air filter clogged?<br />
Defective or worn drum support<br />
brackets?<br />
Adjust or replace seals.<br />
Clean or replace air filter.<br />
Apply grease to bracket or replace.<br />
B lades adjusted too tight?<br />
Adjust blades until they almost touch side walls of drum.<br />
Loss<br />
of power.<br />
L ow hydraulic fluid<br />
Check hydraulic fluid sight glass. Add fluid if low.<br />
PAGE 20 — WHITEMAN <strong>WM</strong>-<strong>120P</strong>/S <strong>HYDRAULIC</strong> <strong>MIXER</strong>— PARTS & OPERATION MANUAL — REV. #3 (05/25/05)