Nissan/Infiniti - Intraphex

More documents

Recommendations

Info

A B C A Mounting Screws B Make sure to keep ribbon cable clear and exposed
Locate and pull back 4 mounting tabs for front faceplate. These will be identified by small pull tabs with de-tents in them to keep the faceplate clipped on. Note: A small pick tool can be used to free the tabs. Once faceplate has been removed, place LCD assembly aside and locate two pieces shown in Fig One is LCD plastic mount (black) and the other is the touch panel glass. Place black plastic frame into original LCD frame (metal) as shown below in Fig. with the ribbon cable groove positioned at the bottom of original LCD frame (metal). Next, place touch panel glass into plastic frame with ribbon cable facing up as shown in Fig. B C A ( Note: foam gasket will be face up.) Re-assemble faceplate with touch panel glass as shown in Fig. Once assembled, remove 4 board mounting screws as shown in Fig. A b (You will no longer need them)
Page 1 and 2: Prodigy One NN-SC-1001 Nissan/Infin
Page 3: Contents
Page 8 and 9: New fasteners in place
Page 10 and 11: New cable connections to be made Fi
Page 13 and 14: Make all connections to Prodigy One
Page 15: 6. ONCE INSTALLATION IS COMPLETE, T

Nissan/Infiniti - Intraphex

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?