Technical data - Industrial Water Equipment Ltd
Technical data - Industrial Water Equipment Ltd
Technical data - Industrial Water Equipment Ltd
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Technical</strong> <strong>data</strong><br />
AP30<br />
AP30<br />
Impeller<br />
The impeller is an open single-vane cast iron impeller<br />
with a clearance of 30 mm. Cast iron is chosen as it is<br />
resistant towards mechanically wearing particles.<br />
The pumps are used for pumping wastewater, sludgecontaining<br />
water, ground water and surface water in<br />
places such as<br />
• holiday homes,<br />
• single-family houses,<br />
• blocks of flats,<br />
• public buildings,<br />
• factories,<br />
• garages,<br />
• underground car parks and<br />
• car wash areas.<br />
Applications as under AP10, but where a larger impeller<br />
clearance is required.<br />
Pump and stator housing<br />
The pump housing and the stator housing are made of<br />
cast iron.<br />
The stator housing is dry, i.e. not oil-filled.<br />
Discharge<br />
All AP30 pumps have a horizontal R 2 discharge port for<br />
threaded connection.<br />
Shaft and bearings<br />
The shaft is made of stainless steel and rotates in maintenance-free<br />
prelubricated ball bearings.<br />
TM01 7174 4099<br />
An adjustable cast iron wear plate is fitted at the inlet<br />
side of the impeller.<br />
Shaft seal<br />
Combination of mechanical shaft seal and lip seal.<br />
The primary shaft seal have silicon carbide/silicon<br />
carbide seal faces.<br />
The secondary shaft seal is a lip seal. The chamber<br />
between the shaft seals is filled with oil.<br />
Standard pumps: 0.01 litre<br />
Ex-pumps:<br />
0.4 litre.<br />
Motor cable<br />
Standard pumps 10 m:<br />
Ex-pumps 10 m:<br />
Materials<br />
Description<br />
Control box<br />
H07RNF.<br />
H07RNF - PLUS.<br />
Materials<br />
DIN<br />
W.-Nr.<br />
AISI/<br />
ASTM<br />
Stator housing Cast iron EN-GJL-250 0.6025 ASTM 35B<br />
Pump housing Cast iron EN-GJL-250 0.6025 ASTM 35B<br />
Neck ring<br />
Bronze<br />
Impeller Cast iron EN-GJL-250 0.6025 ASTM 35B<br />
Wear plate Cast iron EN-GJL-250 0.6025 ASTM 35B<br />
Shaft Stainless steel 1.4104 AISI 430F<br />
Bearings<br />
Heavy-duty prelubricated ball bearings<br />
Screws Stainless steel 1.4301 AISI 304<br />
Oil<br />
Shell Ondina 15, non-toxic<br />
Further information about control box, float switch, and<br />
level control, see page 44.<br />
TM00 3561 5093<br />
17