INSTALLATION OF ANTI-COLLAPSE MESH Storage of materials ...

i) The brackets will be bolted to the racking using m10 x 20mm bolts, washers
and m10 nuts, these fixings will be tightened using 17mm spanners or
sockets.
j) The panels will be built by joining two panels together with the clamps as in
(b) and lifting them into the pre-fitted brackets (first and top row only).
k) This will continue until the entire first row is fitted, the last panel will require
cutting to length to achieve the overall required length.
l) Further lifts can be and will be fitted in the same manner expect the clamps
up to 3m high.
m) Panel rows between first and last are only bolted in the horizontal join, the
brick pattern holds the panels together on all other,
n) After 2m high two operatives working from within the racking and using
harnesses will complete the process as described in (h).
o) This process will be continued by the two operatives until the screen is
complete.
p) Once the screen is built the final cut panel will fitted with a capping strip or
finishing kit.
q) After 3m high two operatives working from within a scissor lift will continue
the process as described in (h).
r) They will place a desired amount of panels in the scissor lift cage, but not to
exceed the lifting capacity, they be lifted to the required height and the panels
will be manually lifted into the brackets as described in (e)
s) The fence once complete will need to be checked and signed off for
completion and acceptance.
Please note the racking and the aisle next to the screen must be clear for this
process of Installation.