Installation Instructions - Hotchkis Sport Suspension

More documents

Recommendations

Info

1967-1969 GM F Body 11R. Remove the chassis brace and using a 7/16” drill bit, drill the 4 holes that you just marked. 12R. Place chassis brace back into place and mark the remaining 4 holes for drilling as shown below. After marking the holes, remove brace and using a 7/16” drill bit, drill the holes. <strong>Hotchkis</strong> Performance LLC. 16
1967-1969 GM F Body 13R. Using the 1718 Hardware kit, pull out the U-Bolts and coat the threading with the Anti- Seize Lubricant. Feed one end of the U-Bolt through one of the holes on either end of the chassis brace and maneuver it into the backside of the other hole as shown below. Place washers and nylock nuts on the U-Bolt. Tighten one side of the U-Bolt partially, and then tighten the other side of the U-Bolt partially alternating back and forth until fully tightened to guarantee the bolt is tightened properly. <strong>Hotchkis</strong> Performance LLC. 17
Page 1 and 2: 1967-1969 GM F Body 2207C Anti-Roll
Page 3 and 4: 1967-1969 GM F Body 5F. Completely
Page 5 and 6: Installing New Hotchkis Anti-Roll B
Page 7 and 8: 1967-1969 GM F Body 8F. Once the ba
Page 9 and 10: 1967-1969 GM F Body 12F. It is best
Page 11 and 12: 1967-1969 GM F Body 4R. Install the
Page 13 and 14: 1967-1969 GM F Body 8R. Remove the
Page 15: 1967-1969 GM F Body NOTE: We have n
Page 19 and 20: 1967-1969 GM F Body 16R. Using the
Page 21 and 22: Hotchkis Performance LLC Return Pol
Page 23 and 24: 1967-1969 GM F Body Effective Decem
Page 25 and 26: Discard Sleeve 12. Put you stock fr
Page 27 and 28: of any salesperson do not constitut

Installation Instructions - Hotchkis Sport Suspension

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?