VECTOR ONE YEAR/TWO YEAR EXTENDED LIMITED ...

To power or recharge the lamp, plug the AC charger/adapter barrel connector into
the Power Port located on the base of the lamp. Plug the AC charger/adapter into
a standard 110 VAC 60 Hz electric socket. Observe that the green LED Lights.
DC CHARGER
This DC Charger allows your lamp to be recharged from a 12 volt source. The 12
volt DC source can be a cigarette lighter type socket on a vehicle or boat, a jump
starter or battery pack, as long as it has a minimum capacity of 10 ampere hours.
Your lamp has a 6 volt, 6 amp hour rechargeable sealed lead acid
battery inside, so the charging voltage should be nominally 7.5 volts. The
supplied DC Charger converts 12 VDC to 7.5 VDC. (See figure 4)
CAUTIONS
- Do not use any other DC Charger with this lamp; you may damage the lamp
charging circuit and void the warranty.
- Do not allow the DC Charger to continuously operate for more than 17 hours.
- The lamp will not accept a charge if the switch is set on and set to dim.
- Recharge time for this lamp is 17 hours with the lamp OFF.
- Operating the lamp during DC recharge will cause damage and void
the warranty
DC RECHARGE
- Make sure the lamp switch is OFF
- Insert the DC plug into the powered DC socket.
- Insert the adapter's barrel connector into the Power Port at the base of
the lamp.
- Observe the green LED and make sure it is lit.
- Charge until the green LED changes to unlit. This indicates full battery charge.
- Disconnect the DC Charger from the DC source and the lamp.
If the lamp does not accept a charge; check the following:
- Make sure the lamp is turned OFF
- Make sure the DC source is providing 12 volts DC.
- Try charging using the AC Charger/Adapter. If the battery accepts the charge,
the DC Charger may be damaged. Call Vector Technical Support.
FIGURE 4
DC CHARGER
3