VECTOR ONE YEAR/TWO YEAR EXTENDED LIMITED ...
VECTOR ONE YEAR/TWO YEAR EXTENDED LIMITED ...
VECTOR ONE YEAR/TWO YEAR EXTENDED LIMITED ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
BULB REPLACEMENT<br />
The supplied 10 watt quartz Halogen lamp is a projection quality bulb.<br />
Operating the lamp at full brightness for long periods reduces the bulb's life.<br />
Using the dimmer extends both bulb life and battery life.<br />
If you suspect the bulb is burned out:<br />
Check if the lamp will light by plugging in the AC charger/adapter and powering<br />
it. If the dimmer is set halfway and the bulb won't light, it probably needs to<br />
be replaced.<br />
No tools are required to replace the bulb; you only need a new replacement bulb<br />
(Vector part# VEC193). The replacement procedure is as follows:<br />
1. Make sure the lamp switch is turned OFF.<br />
2. Grasp the clear plastic guard and the plastic disk below and unscrew the<br />
guard from the disk (counterclockwise). Set the guard aside.<br />
3. Using a clean cloth grasp the bulb and pull the bulb straight up and remove it.<br />
Set the bulb aside.<br />
4. Using a clean cloth, grasp the new bulb and remove it from the container.<br />
Avoid touching the new bulb with bare skin.<br />
5. Note the positions of the bulb's two pins and the small holes on the bulb<br />
socket.<br />
6. Insert the two pins of the new bulb into the socket and make sure they are fully<br />
seated in the socket.<br />
7. Turn on the dimmer and test operation of the bulb.<br />
8. Turn off the lamp and replace the clear plastic guard. Carefully tighten<br />
(clockwise).<br />
9. Place the shade on the top of the guard.<br />
10. Replace the Diffuser and finger-tighten it to secure the shade (clockwise).<br />
11. Dispose of the burned out bulb in a responsible manner.<br />
CLEANING<br />
Over time, there may be dust or fingerprints on the lamp. If necessary clean the<br />
lamp with a soft clean oil-free cloth moistened with window cleaner. Do not use<br />
alcohol-based cleaners on plastic surfaces, this will eventually cause surface clouding.<br />
If the inside of the plastic guard becomes dirty, disassemble as you would for<br />
bulb replacement and clean with window cleaner as above.<br />
BATTERY CARE<br />
Lead-acid batteries should be recharged on a regular basis to maintain a full<br />
charge and to ensure good battery life. All lead-acid batteries suffer from self-discharge<br />
over time and more rapidly when they are at higher temperatures.<br />
Therefore, these types of batteries need periodic charging to replace energy lost<br />
through self-discharge. When the lamp is not in use, Vector recommends that the<br />
battery is recharged at least every 60 days. All batteries must be recharged as<br />
soon as possible after each use. If a battery is allowed to remain in a discharged<br />
state, battery life will be reduced.<br />
NOTE: Recharging battery after each use will prolong battery life; frequent heavy<br />
discharges between recharges will reduce battery life. You can not overcharge<br />
the battery with the supplied AC charger/adapter. The time<br />
required to fully recharge the battery depends on the charge status of the<br />
4