Catalina Owner's Manual - Chris Craft
Catalina Owner's Manual - Chris Craft
Catalina Owner's Manual - Chris Craft
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Systems<br />
Using the Fresh Water System<br />
The water tank fill deck plate may be located in the general vicinity<br />
of the fuel fill deck plate. DO NOT put fuel in the water tank or water<br />
in the fuel tank.<br />
Always keep the fresh water tank full. A full water tank helps keep the water potable. To fill the water<br />
tank:<br />
1. Ensure the water supply is suitable for drinking. If filling from the dock check with the dockmaster to verify the<br />
water is potable.<br />
2. Remove the filler cap and fill the tank until water flows from the vent.<br />
3. Secure the filler cap.<br />
You will need to start the system whenever the tank is empty and air is in the supply lines. To start/use the<br />
fresh water system:<br />
1. Sanitize the system as previously described.<br />
2. Fill the water tank with potable water.<br />
3. Energize the pressure pump.<br />
– The boat must have electrical power to energize the pressure pump. This can be the batteries, or if so<br />
equipped, an external power source.<br />
– Turn on the water pressure switch on the salon circuit breaker panel.<br />
4. Starting with the cold water faucet furthest from the pump, open each faucet until you see a steady stream of<br />
water from each faucet. Close the faucets.<br />
5. Open the faucet(s) and run until you see a steady stream of water from each faucet. Close the faucets.<br />
6. Refill the water tank and turn off the pressure pump.<br />
3–26 <strong>Chris</strong>-<strong>Craft</strong>