Download the Full PDF Catalog - Schlueter Dairy Technologies

MilkpumpsReceiversFiltersandWashers
maximizer Variable
speed milk pump
LIQUID LEVEL CONTROL
Features:
• High pump speed on low level float
during wash cycle eliminates
trap-over and improves wash volume
• Optimizes pre-cooler performance
using up to 50% less water
• Automatic adjustment with 3 speed
ranges for minimum milk flow,
maximum milk flow,
and wash
• Deluxe system
includes Nema
4 enclosure with
wash/manual
switching assembly.
• Optimizes
energy efficiency
& maximizes
equipment
longevity
The standard
probe is now 34”
overall length.
Actuation levels
are at 1”, 4”,
& 8” from the
bottom.
There is about
20” of up/down
adjustment from
the top float to
the sealing face
of the adjusting
grommet.
Top Float
Level 3=20” max
Middle Float
Level 2=24” max
Bottom Float
Level 1=28” max
Std. Deluxe Std. Deluxe
Description 230V 230V 460V 460V
1 to 3 HP VSC 45703 45703-A 45703-B 45703-C
5 HP VSC 45704 45704-A 45704-B 45704-C
Description Part #
1 Float Assy. for 18”-30” Receiver 45705
3 Float Assy. for 18”-30” Receiver 45706
4 Float Assy. for 48” Balance Tank 45707
(3 Speeds - 1 Alarm)
Plastic Float 45705-1
Stainless Steel Float 45705-3
Stainless Steel Circlip 45705-2
Rubber Probe Holder 45706-5
Stainless Steel Locking Collar 45706-6
Time Delay for VSC 45700-9
• Custom Probe assemblies available upon request
• Allow three week lead time
Variable speed milk pump controls have an available
dump relay feature that will maintain the milk pump
in manual for a pre-set time, then switch on the airblow
valve automatically. Both timers are adjustable.
Safgard Liquid Level Control
LLC WITH 3 PROBES
• Follow federal, state & local electrical
codes when installing
Fits 1-1/2” hole
for Ss receivers
Description Part #
110 Volt 48680
220 Volt 48680-2
Also fits 2” Tri-Clamp Connection
Parts Description Part #
110V Control less probe assy. 48680-1
220V Control less probe assy. 48680-3
110V Replacement board 48778
220V Replacement board 48778-1
Contactor 110 volt 45723
Contactor 220 volt 45724
SPDT switch 45782
2” Tri-Clamp Style Probe 45769-1
1 1/2” Plug Style Probe 45769-2
Long probe 23” 45770
Short probe 19” 45771
Electrode cord w/ cap 45784
Probes can be cut to alternate lengths at the job site.
Refer to wiring diagram page 129.
Replacement
MILK PUMP MOTORS
For Schlueter, Universal, Bou-Matic Sta-Rite , Surge and
others.
Not your standard replacement motor. Schlueter’s special duty milk
pump motors have stainless steel shafts, electronic start switches,
Description Part #
3/4 HP 1 Phase 48742
1 HP 1 Phase 48743
1 HP 3 Phase 48743-1
1-1/2 HP 1 Phase 48744
1-1/2 HP 3 Phase 48744-1
Keyed shaft motors
Description Part #
2 HP 1 Phase 5/8” Shaft 25496
2 HP 3 Phase 5/8” Shaft 25496-1
2 HP 1 Phase 7/8” Shaft 25497
2 HP 3 Phase 7/8” Shaft 25498
3 HP 3 Phase 7/8” Shaft 25500-1
All motors are Type C-Face, 3450 RPM. 3-Phase motors are all 230/460 volts.
Acme Threaded and Surge
Shafted Replacement
Motors
Threaded shaft motor fits
Bou-Matic, and Sta-Rite/
Universal pump heads.
Description Part #
1/2 HP 115 V-230V 25556
1 HP 220V - 1 Phase 25616
1 HP 220V - 3 Phase 25617
Replacement for Surge
1/2 HP 1 Phase motor* 25618
1 HP 1 Phase motor * 25619
1 HP 3 Phase 25620
*Motor fitted w/ externally
mounted capacitor. Remove the
capacitor in the original control
35
Janesville, WI 800.359.1700 • Fresno, CA 800.359.1702 • York, PA 800.359.1701
schlueterco.com