AG SELECT 2.3 software Instruction manual - Etatron

More documents

Recommendations

Info

If Windows XP is configured to warn when unsigned (non-WHQL certified) drivers are about to be installed, the following screen will be displayed unless installing a Microsoft WHQL certified driver. Click on "Continue Anyway" to continue with the installation. If Windows XP is configured to ignore file signature warnings, no message will appear. The following screen will be displayed as Windows XP copies the required driver files. 22
Windows should then display a message indicating that the installation was successful. Click "Finish" to complete the installation for the first port of the device. If the device is based on the FT2232C, the second port must also be installed. The procedure for installing the second port is identical to that for installing the first port from the first screen of the Found New Hardware Wizard for the USB Serial Port device. If the driver is Microsoft WHQL certified, this is done automatically. Open the Device Manager (located in "Control Panel\System" then select the "Hardware" tab and click "Device Manger") and select "View > Devices by Connection", the device appears as a "USB Serial Converter" with an 23
Page 1 and 2: AG SELECT 2.3 software Instruction
Page 3 and 4: Run Setup AG Select 2.3.exe file Se
Page 5 and 6: Press Install to start the installa
Page 7 and 8: 2. Toolbar menu 3. Memory Card Menu
Page 9 and 10: 4. Graphics Menu To visualize data
Page 11 and 12: 6. Configuration Menu General setup
Page 13 and 14: Select type of intervention require
Page 15 and 16: 9. AG SELECT - PC connection Cable
Page 17 and 18: 10. USB Drivers installation Instal
Page 19 and 20: If Windows XP is configured to warn
Page 21: The Found New Hardware Wizard will
Page 25: Uninstalling FTDI Devices When unin

AG SELECT 2.3 software Instruction manual - Etatron

Create successful ePaper yourself

Delete template?

Save as template?