HT EV801 HITAGâ¢ Long Range Evaluation Kit - AdvanIDe

More documents

Recommendations

Info

October 2005 Rev. 1.0 Long Range Evaluation Description 7. R/W-Device Get Version: Reads the version and programming date of the firmware and the serial number of the Core Module. Page 22 of 36 HTEV801 REV.1.00.doc/RF
October 2005 Rev. 1.0 Long Range Evaluation Description StartFFT: ReadLRStatus: Set PowerDown: Set BCD: SetBaudRate: SetOutput: ReadInput: Port Commands: DSP Version: This command starts the Fast Fourier Transformation (FFT) of the Digital Signal Processor. This command is to be used as often as required depending on the noisefloor of the environment. Note that no TTF transponder is in the field when starting FFT This command can be used to check the antenna status (broken or badly detuning antennas can be detected). Antenna drivers can be switched on or off. This command adjusts the timing of the read/write device to the antenna. The command has to be operated once, when an antenna is connected for the first time or changed, it can be done with or without successing FFT. Baudrates from 9600 to 57600 kHz can be chosen, be aware that after a power reset the Baudrate switches back to 9600. Out1-4 can be cleared or set, only Out1 is available at the HTRM801. Read status of In1/2. Not in use. Not in use. *) The commands Fast Fourier and Set BCD are only enabled when using HITAG Long Range Read/Write Devices. Page 23 of 36 HTEV801 REV.1.00.doc/RF
Page 1 and 2: HT EV801 HITAG Long Range Evaluatio
Page 3 and 4: October 2005 Rev. 1.0 Long Range Ev
Page 21: October 2005 Rev. 1.0 Long Range Ev
Page 35: Frosch Electronics OEG Customized R

HT EV801 HITAGâ¢ Long Range Evaluation Kit - AdvanIDe

Create successful ePaper yourself

Delete template?

Save as template?

HT EV801 HITAGâ¢ Long Range Evaluation Kit - AdvanIDe