Ground (0V) +24 V Power connections - Hiab AS

More documents

Recommendations

Info

Control Box CB V2 1) Normal Control Box - Check that there is a jumper in dead man switch - CAN Enable is free - GND wire from Rubber Gaiter is connected to Case GND CAN Enable (grey) CAN1 H (yellow) (M12 pin 3) CAN1 L (green) (M12 pin 4) Case GND (grey) (Rubber Gaiter) GND (white) (M12 pin 1) +24 V (brown) (M12 pin 2) 2) Remote Control Box - Check that all 6 wires are connected - Check that connector is tightened and wires aren’t twisted and connected together. CAN Enable (grey) (LEMO pin 5) CAN1 H (yellow) (LEMO pin 3) CAN1 L (green) (LEMO pin 4) Case GND (grey) (2 wires, Rubber Gaiter & LEMO pin 6) GND (white) (LEMO pin 1) +24 V (brown) (LEMO pin 2)
Control Box PCB V2 LED in control box Red Green Description OFF OFF - Supply voltage is missing -Power save mode active (remote controls) - Software or bootloader is missing ON OFF - Downloading software - software is missing OFF ON Software is running ok
Page 1 and 2: Power connections 3) Power from 202
Page 3 and 4: CAN connections 2) CAN High & Low i
Page 5: Control Box V1 LED in control box R
Page 9: Software When Service Tool (PC or S

Ground (0V) +24 V Power connections - Hiab AS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?