For the models FX4 / FX5 / FX6 / RF1 - Rewaco Spezialfahrzeuge ...

Malfunctions 19
Malfunctions
Vehicle electrical system
Fuse assignment, control panel:
The control panel is located behind the passenger seat.
Blown fuses must be replaced.
Reserve fuses are located in the free slots on the control
panel. Please proceed as follows when changing a
defective fuse:
• Switch off the ignition and the affected electric load
• Find out which fuse belongs to the failed electric
load (see right side)
• Remove the concerned fuse
• If the fuse has blown (you can recognise this by the
molten metal strip), replace it with a fuse of the same
strength
! If the malfunction cannot be rectified by exchanging
a defective fuse, the electrical system must be checked
as quickly as possible by a rewaco partner dealership.
Multiple changes of a defective fuse can lead to further
damage.
1 10 A
2 10 A
3
4
5 15 A
6 15 A
7 15 A
8 10 A
9 10 A
10 20 A
25 A 20 A 20 A
1 Engine control
2 Warning blinker switch
3 Free
4 Free
5 Generator / reverse light
6 Combined instruments /
Tank dummy
7 Brake light
8 Side light, right /
Rear fog light
9 Side light left
10 Engine control
radiator
fan
low beam
light
high
beam
control
unit
blinker
two tone
horn
starter
fog
light
fuel
pump
20 A
25 A 20 A 15 A