Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3-2 MODEL <strong>22</strong> SERIES <strong>II</strong> OPERATIONS AND MAINTENANCE MANUAL<br />
INTRODUCTION<br />
Accu-Sort Systems<br />
This chapter explains how to supply power to your <strong>Model</strong> <strong>22</strong> <strong>Series</strong> <strong>II</strong>, and how<br />
to connect your <strong>Model</strong> <strong>22</strong> <strong>Series</strong> <strong>II</strong> to a PC and TERMINAL. This chapter also<br />
explains how to connect a photoeye, tachometer, and interface box to your <strong>Model</strong><br />
<strong>22</strong> <strong>Series</strong> <strong>II</strong>. You must make these connections before you can begin setting up or<br />
using your <strong>Model</strong> <strong>22</strong> <strong>Series</strong> <strong>II</strong>.<br />
MAKING CONNECTIONS TO YOUR MODEL <strong>22</strong><br />
SERIES <strong>II</strong><br />
There are four connectors on the rear of the <strong>Model</strong> <strong>22</strong> <strong>Series</strong> <strong>II</strong>. There are two<br />
serial communications ports, one power port, and one trigger port. The following<br />
are the port definitions on the <strong>Model</strong> <strong>22</strong> <strong>Series</strong> <strong>II</strong> connector panel:<br />
• J1 (COM1) - 15-pin male 'D' connector (serial port)<br />
• J2 (Trigger) - 9-pin female 'D' connector<br />
• J3 (COM2) - 15-pin male 'D' connector (serial port)<br />
• J4 (Power) - 5 pin EuroFast connector<br />
Refer to the drawing to the right. It shows the <strong>Model</strong> <strong>22</strong> <strong>Series</strong> <strong>II</strong> connector panel<br />
and details the pins for each 'D' connector. Refer to the Wiring Other Sources of<br />
Power Section of this chapter for the pin definitions of the J4 power connector.
Change language