Model 22 Series II - Cybarcode, Inc.

3-6 MODEL 22 SERIES II OPERATIONS AND MAINTENANCE MANUAL
MAKING COMMUNICATION CONNECTIONS TO
OTHER EXTERNAL DEVICES
Accu-Sort Systems
The Model 22 Series II is versatile when you need to connect to other devices.
The drawings below show all the pin connections for the Model 22 Series II
when using serial communications on port J1 or J3. If you need to create your
own cables to wire your Model 22 Series II to another device, use these drawings
as a guide. It is very important that you make the proper pin connections. Use
Accu-Sort mating connector (PN 1000012239) or equivalent 15-pin female
connector.
Below is a list of terms used in these drawings:
GND Ground RXD Receive Data (RS232)
TXD Transmit Data(RS232) RTS Request To Send (RS232) – J3 only
CTS Clear To Send (RS232) – J3 only RD+ Receive Data (RS422)
RD Received Data (RS422)
SD+ Non-inverting Line (RS485)
SD Inverting Line (RS485)
Send Data (RS422)
Send Data (RS422)
RS232 WITH NO HANDSHAKING
Use the following drawing as a guide when you want to connect your Model 22
Series II to a device that is using RS232 communication with no handshaking:
NOTE: All connectors are shown from the soldering side.
Model 22 (J1 or J3) HOST
Recommended Cable Type: ALPHA # 5473C or equivalent
Maximum Cable Length: 50 feet
RS232 WITH RTS/CTS HANDSHAKING (J3 ONLY)
RS232 with RTS/CTS handshaking is available on the J3 port only. Use the
following drawing as a guide when you want to connect your Model 22 Series II
to a device that is using RS232 communication with RTS/CTS handshaking:
NOTE: All connectors are shown from the soldering side.
Model 22 (J3 only) HOST
Recommended Cable Type: ALPHA # 5473C or equivalent
Maximum Cable Length: 50 feet