MegaGrow Greenhouse Manual - International Greenhouse Company

Side Assembly
SECTION-1
Tools Required: -7/16” Box Wrench.
Side parts Pack
(1) Side Cill (Item # 1).
(1) Gutter (Item # 2).
(2) Side Brace (Item # 4). NOTE:- The Side Brace is distinguishable from the
end brace by its length . The side brace is the longer of the two.
Glazing bars (For required number see chart ).
ASSEMBLY
STEP-1 Lay out parts see (PIC-1) Gutter to the top cill at the bottom.
STEP-2 Install “T” bolts in to gutter as (PIC-3) leve lose as shown.
STEP-2 Assemble Glazing bars to the gutter section using bolts from (STEP-2).
STEP-3 place “T” bolts into open end of glazing bar aprox ½” in from end
(see PIC-4) and mount to cill using second hole in from the end, because
this is the outside glazing bar place one end of the side brace onto the
“T” bolt before installing the nut. Install all remaining G/bars repeat the
procedure for the last G/bar using the remaining side brace, remember the
inside face must face out.
NOTE:- The inside face of the brace should face towards the end of the
side wall.
STEP-4 Secure the remaining (2) lose ends of the brace to the end slots in the gutter
section using a ”T” bolt, this is to temporarily support the brace to stop
damage until installing in (SECTION-4 Main assembly)
NOTE:- DO NOT TIGHTEN BOLTS AT THIS TIME “ SNUG UP ONLY”.
REPEAT ABOVE FOR THE SECOND SIDE.