DH-2000 Operator Manual - Qas-inc.com

More documents

Recommendations

Info

A: Maintenance 5. Insert the new Halogen lamp module and Replace the screw (21). 6. Reattach the two cables of the Halogen lamp module to the cable-clamp. 7. Reassemble the unit by reversing the disassembly steps. 20 000-10000-025-02-0408
Appendix B Supplementary Information for Models DH-2000-S and DH-2000-FHS Overview The following information applies to specific models of the DH-2000. Read the instructions and refer to the figures on page 23. DH-2000-S (With TTL Shutter Control) Automatic Operation Plug SUB-D 15-pin TTL connector into socket on rear of DH-2000-S. Manual Operation Manually set operating mode using the toggle switch on the front of the DH-2000-S: • Open - Shutter open (left position) • Close - Shutter closed (center position) • TTL - Controls shutter with external TTL signal (High = Open, Low = Close) using software and spectrometer 000-10000-025-02-0408 21
Page 1 and 2: Deuterium-Halogen Light Source DH-2
Page 3: Important Safety Notices 1. Do not
Page 6 and 7: Table of Contents Halogen Lamp ....
Page 8 and 9: About This Manual Upgrades Occasion
Page 10 and 11: 1: Setup Unpacking the DH-2000 ►
Page 12 and 13: 1: Setup 4 000-10000-025-02-0408
Page 14 and 15: 2: DH-2000 Specifications Front Pan
Page 16 and 17: 2: DH-2000 Specifications Specifica
Page 18 and 19: 2: DH-2000 Specifications Note Modi
Page 20 and 21: 3: Operating Instructions Warming U
Page 22 and 23: 4: Troubleshooting Halogen Lamp If
Page 24 and 25: A: Maintenance Replacing the Deuter
Page 26 and 27: A: Maintenance Replacing the Haloge
Page 30 and 31: B: Supplementary Information for Mo
Page 32 and 33: B: Supplementary Information for Mo
Page 34: Index 26 000-10000-025-02-0408

DH-2000 Operator Manual - Qas-inc.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?