User Manual - Tranberg

TEF 1060PRESSURIZED ENCLOSURESUSER MANUALIMPORTANTRead this instruction carefully before installing theproduct100A8025TUM 1031Tranberg AS | P.O. Box 8033 | N-4068 Stavanger | Norway | Tel.: (47)51 57 89 00 | Fax.: (47)51 57 89 50E-mail: info@tranberg.com | www.tranberg.comTranberg Systems | Hjulmagervej 15C | 7100 Vejle | Denmark | Tel.: (45) 75 85 83 80E-mail: mail@tranbergsystems.com | www.tranbergsystems.com

TEF 1060 PRESSURIZED ENCLOSURE USER MANUALINTRODUCTIONThank you for purchasing this product!For installation, maintenance and assurance of a long lifeof this product, please follow this manual.APPROVALSCertificate of conformatyExplosion category: II 2 GD EEx p IICertificate No.: NEMKO 05ATEX1160UNotified Body: Nemko AS, NorwaySAFETY INSTRUCTIONTranberg series 1060 enclosures are not suitable for use inzone 0 hazardous areas.Changes made to the product which do not confirm theapprovals of this equipment, is a safety violation. Themanufacturer is under no circumstances responsible forpersonal injuries, death or any other damage caused bysuch activities.For replacement and repair of the enclosure only TranbergAS spare parts may be used.MAINTENANCE / REPAIR / MODIFICATIONBefore opening the enclosure make sure that the power isdisconnected.Servicing the enclosure is done by checking the intactnessof the enclosure, gasket and glands. If necessary lubricatethe lid bolt threads or the quick lock closing with greasetype Renolit Unitemp 2 from Fuchs or equal.this may onlybe done with Tranberg spare parts..

TEF 1060 PRESSURIZED ENCLOSURE USER MANUALINSTALLATIONOnly qualified personnel are allowed to performinstallation and maintenance tasks to this equipment.The enclosure holds a component certificate whichindicates that the certificate must not be mistaken for acertificate of an equipment or protective system. Thepartial certificate may be used as a basis for certification ofan equipment or protective system.Installation has to be done according to equipment orprotective system requirement.MountingThe 1060 enclosure must be fastened by 4 pcs. of M10bolts, or M8 bolt at holes in back of enclosureConnectionClose and lock door / lid. In case of bolt tight these firmlywith suitable tool by hand force. Over tightening mayimpair the protection category.

TEF 1060 PRESSURIZED ENCLOSURE USER MANUALTECHNICAL DATAHousing:IP-rating:Tamb:Compliance with:Maximum volume:Maximum overpressure:Maximum leakage/flow rate:Area of use:Acid proof stainless steelIP6620°C to +40°CEN50014:1997+A1:1999+A2:19992367L8mbar14L/min.Zone 1, Zone 2 and safe areaTranberg AS | P.O. Box 8033 | N-4068 Stavanger | Norway | Tel.: (47)51 57 89 00 | Fax.: (47)51 57 89 50E-mail: info@tranberg.com | www.tranberg.comTranberg Systems | Hjulmagervej 15C | 7100 Vejle | Denmark | Tel.: (45) 75 85 83 80E-mail: mail@tranbergsystems.com | www.tranbergsystems.com