SAM4s SER-7000 SER-7040 Programming Manual.pdf

Memory Allocation Program NotesFIELD1 # OF DIGITS IN REPORTTOTALS (8-10)2 # OF DIGITS IN REPORTCOUNTERS (6-8)NotesDetermine the maximum size of report totals:8, 9 or 10 digits.Your choice assumes two digits to the right ofthe decimal. For example 6 digits =XXXX.XX or 7 digits = XXXXX.XX.3 # OF PLU Determine the total # of PLUs, includingPLUs by code, by scanning or bykeyboard/keyboard level.4 # OF PLU STATUS GROUPS Determine the maximum number of statusgroups to which you link PLUs. See "PLUStatus Group (PLU Status Link)" in "P-ModeProgramming" for more information.5 # OF PRICE LEVELS PERPLU (1-4)6 PLU REPORT BY PRICELEVELPrices may be assigned at up to four differentprice levels for each PLU. If you wish to useprice levels, you must determine the numberof price levels here. If Price levels are set,they are set for all PLUs.If selected, the PLU report will detail sales ateach level, rather than a total and counter forsales at all levels combined.7 # OF EMPLOYEES Determine the total number of employees andset the maximum use wish to use here.Employees include all who use the registerfor any purpose, including those using onlythe time clock feature for clocking in/out.8 # OF TIME ENTRIES PEREMPLOYEEDetermine the maximum number of clockentries that can be stored in the Z1 report.After Z1, only summaries are stored on Z2reports (or Z3, Z4 or Z5 reports, ifimplemented.)9 USE GROUP BY EMPLOYEE Determine if you wish to report GROUPS byEMPLOYEE. If you choose Y, then you canreport up to 30 of the 99 groups for eachemployee. See "Groups By Employee" onpage 205 to select which groups will reportfor each employee.10 CHECK TRACKING METHOD Choose HARD or SOFT. Hard checks storeonly the check balances; soft check storecheck detail for the number of linesdetermined at step 12.36 S-Mode Programming SER-7000 Program Manual