MSD Tech Line - MSD Powersports

www.msdpowersports.comMSD PULSE IGNITION, PN 42211wiring the voes control switch.An auxiliary SPDT Switch (not included in the MSD Pulse kit) may be used to easily turn theVOES Curve on or off. Connect the White wire of the MSD and a wire of the VOES Switch toone terminal of the Switch. The other terminal of the switch goes to ground.• When the switch is OPEN, the VOES curve is enabled via the VOES Switch. This is suitedfor less aggressive operation and highway cruising.• When the switch is closed (connected to ground), the VOES curve is disabled. Thisconfiguration reverts to the basic advance program, providing full advance at all enginespeeds in excess of the programmed max timing rpm value 1,750 to 3,500 rpm.trouble shooting32inoperative TachometerThe MSD Pulse Ignition delivers a conventional 12-13 volt square wave signal that iscompatible with most factory tachometers. Some aftermarket tachometers require a highvoltage spike. If the tachometer does not operate properly, an MSD PN 8920 Tach Adaptorshould be used to provide a suitable signal.Check Wiring• Check wiring routing and connections.• Make sure all of the terminals and pins are crimped tightly and are fully seated in theconnectors.• Confirm all of the connections with the wiring diagram in the installation instructions.• If any wires or connections have been modified or shortened, use an ohm meter to confirmcontinuity through the connectors.Check the Battery• Verify the Red wire of the MSD is firmly connected to the positive (+) battery terminal.• Verify the Black wire is firmly connected to the negative (-) battery terminal.Battery Condition: Connect a volt-ohm meter across the battery to check battery voltage. Ifthe meter indicates less than 10 volts static (non-cranking, ignition switch On) or less than 7volts while cranking the engine with the starter, the MSD Pulse will not operate properly.Ignition Supply: Check for a 12-volt input to the MSD Module. With the ignition switch On,use a volt-ohm meter to verify that at least 10 volts is supplied to the MSD Violet wire. If lessthan 10 volts is supplied, the MSD Pulse will not operate properly.MSD POWERSPORTS • 1490 Henry Brennan DR., El Paso, Texas 79936 • (915) 858-3365 • FAX (915) 858-3496