SYSTEM KAN-therm KAN-therm SYSTEM - broen-sei

KAN-therm Push System - screwed connections 3Screwed connections for PE-RT and PE-Xc pipesRules for making a screwed connection:1. Screw in connector body into fitting with screw thread sealing.2. Place nut and ring on the pipe.3. Slide the pipe on the connector body and screw on the nut clamping the ring.1. Fitting - female tee.2. Straight male connector (body).3. Compression ring.4. Clamping nut.5. PE-RT or PE-Xc pipe.Insert the compression ring on the pipe and the ring edge should be 0.5 to 1 mm distant from the pipe edge. The pipeshould be slid to the end of connector body. The connection can be considered as dismountable provided after exiting thepipe, by the connector body the used end of pipe is cut off and a new connection is made.It is not allowed to rotate the fitting against the pipe during and after the assembly or use any pastes to make the sliding ofpipe onto the connector body easier.Screwed connectors operate with: fittings with internal threads, e.g. elbows, tees, tap connectors, manifolds without nipples (without accesories); fixtures with internal threads.Connections of that type: should be sealed by hemp (threads) with addition of pastes, in the case of internal brass threads making sure there is noexcess tow; internal brass threads (cylindrical thread contour) should not be connected with pipe external threads (conical threadcontour) because of danger of brass fracture; apply a rule that connectors and fittings with internal threads should not be connected with elements which are notincluded in KAN-therm System. should not be concealed in floors.- 12 -