Datalogic Heron D130 Quick Reference Guide - The Barcode ...

More documents

Recommendations

Info

First Start-UpConnect <strong>Heron</strong>to HostGreen LED blinksLoad drivers(if requested)Green LED offDisconnect readerat HostYESDoes a dialogbox appearwarning that Buspower is notsufficient?Connect externalpower supply tocable and power upNOGreen LED off - BEEP OKBEEP OKReconnect readercable to Host andclose dialog boxSelect desired USBinterface code(USB-KBD is default)Load drivers(if requested)Read test codes.Reader is READYSuccessive start-ups will automatically recognize the previouslyloaded drivers. If external power is used, verify that externalpower is already supplied.Successive Start-UpsConnect <strong>Heron</strong> toHostGreen LED blinksDisconnect readerat HostYESDoes a dialog boxappear warningthat Bus power isnot sufficient?Connect externalpower supply tocable and power upNOGreen LED off - BEEP OKBEEP OKReconnect readercable to Host andclose dialog boxRead test codes.Reader is READY
USB INTERFACE SELECTIONUSB-KBDÌ$+UA03$-:ÎUSB-KBD-ALT-MODEÌ$+UA04$-@ÎUSB-KBD-APPLEÌ$+UA05$-FÎUSB-COM*Ì$+UA02$-4ÎUSB-IBM-Table TopÌ$+UA00$-(ÎUSB-IBM-Hand HeldÌ$+UA01$-.Î* When configuring USB-COM, the relevant files and driversmust be installed from the USB Device Installation software,which can be downloaded from the web sitehttp://www.datalogic.com.
Page 3 and 4: USING HERON SERIES READERSHeron gun
Page 5 and 6: WEDGEDISCONNECTING THE CABLE
Page 7: INTERFACE SELECTIONFollow the proce
Page 11 and 12: RS232 READER CONFIGURATIONRead the
Page 13 and 14: WEDGE (CONTINUED)IBM Terminals 31xx
Page 15 and 16: WEDGE KEYBOARD NATIONALITYWedge use
Page 19 and 20: OPERATING TESTRead the TEST codes b
Page 21: READING DIAGRAM15Reading Zones (10

Datalogic Heron D130 Quick Reference Guide - The Barcode ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?