A Study of Hole Drilling on Stainless Steel AISI 431 by EDM Using ...

However, it is reverse proportion to water pressure and duty factor.5 AcknowledgementThis work was supported by the National Research University Project <strong>of</strong> Thailand Office<strong>of</strong> Higher Education Commission and the National Research Council <strong>of</strong> Thailand (NRCT).6 ReferencesAli S., Hinduja S., Atkinson J., Pandya M. (2009). Shaped tube electrochemical drilling <strong>of</strong> goodquality holes. CIRP Annals - Manufacturing Technology , 58, 185-188.Bilgi D.S., Jain V.K., Shekhar R., Kulkarni A. (2007). <strong>Hole</strong> quality and inter-electrode gapdynamics during pulse current electrochemical deep hole drilling. International Journal<strong>of</strong> Advanced Manufacturing Technology, 34, 79-95.Choi I-H.,Kim J-D. (1998). A study <strong>of</strong> the characteristics <strong>of</strong> the electrochemical deburring <strong>of</strong> agovernor-shaft cross hole. Journal <strong>of</strong> Material Processing Technology, 75, 198-203.Diver C., Atkinson J., Helml H.J., Li L. (2004). Micro-EDM drilling <strong>of</strong> tapered hole forindustrial applications. Journal <strong>of</strong> Material Processing Technology, 149, 296-303.Fukuzawa Y., Mohri N., Tani T. and Muttamara A. (2004). Electrical discharge machiningproperties <strong>of</strong> noble crystals. Journal <strong>of</strong> Materials Processing Technology, 149(1-3), 393-397.Guitrau E.B. (1997). The EDM Handbook. Handser Gardner publication Cincinnati, 19-54.Han F., Wachi S., Kunieda M. (2004). Improvement <strong>of</strong> machining characteristics <strong>of</strong> micro-EDM using transistor type isopulse generator and servo feed control. PrecisionEngineering, 28, 378–385.Jeong Y. H., Min B. K. (2007). Geometry prediction <strong>of</strong> EDM-drilled holes and tool electrodeshapes <strong>of</strong> micro-EDM process using simulation. International Journal <strong>of</strong> Machine Tooland Manufacture , 47, 187-1826.Muttamara A., Fukuzawa Y., Mohri N., and Tani T. (2009). Effect <strong>of</strong> electrode Materials onEDM <strong>of</strong> Alumina. Journal <strong>of</strong> Materials Processing Technology, 209, 2545-2552.Muttamara A., Janmanee P., and Fukuzawa Y.(2010). A <strong>Study</strong> <strong>of</strong> Micro–EDM on SiliconNitride Using Electrode Materials. International Transaction Journal <strong>of</strong> Engineering,Management, & Applied Sciences & Technologies, 1(1), 1-7.Rajasekhar A., Madhusudhan Reddy G., Mohandas T. (2009). V.S.R. Murti. Influence <strong>of</strong>austenitizing temperature on microstructure and mechanical properties <strong>of</strong> AISI 431martensitic stainless steel electron beam welds. Materials and Design, 30, 1612-1624.480 Pichai Janmanee, and Apiwat Muttamara