Operator's manual (PDF) - McElroy Manufacturing, Inc.

InstallationConnecting To A Fusion MachineNOTICE: The fusion machine must have a hydraulicquick disconnect for connecting the DataLoggerTMpressure transducer. If the machine does not haveone, contact your distributor for the proper adapter orretrofit kit.NOTICE: make sure the fusion machine hydraulicpump is turned off and the pressure is at 0 psi beforeconnecting the DataLogger TM to the fusion machine.PH01168-6-9-97TX01336-4-28-97No.28, No.412 and No.618 FusionMachinesLoosen the thumb screw on the back of the unit.Place the slotted swivel adapter on the back of theunit over the top rectangular bar around the hydraulicmanifold. Position the unit on the bar and lightlytighten the thumbscrew.Remove the pressure transducer from the holder onthe unit by pulling down on the knurled collar on thequick disconnect. Connect the pressure transducerquick disconnect to the fusion machine quickdisconnect.PH01174-6-9-97TX01337-4-28-97Mc28 Pit Bull TM , No.824, No.1236,No.1648 & No.2063Fusion MachinesThe Mc28 Pit Bull TM and all MegaMc ® machinesexcept the No.1236 require an adapter to mount theDataLogger TM on the bar surrounding the manualhydraulic controls. Install the adapter in a convenientplace on the bar. Tighten the adapter. Loosen thethumbscrew on the back of the DataLogger TM unit andplace the unit on the bar (1236) or on the bar adapter.Lightly tighten the thumbscrew.Remove the pressure transducer from the holder onthe unit by pulling down on the knurled collar on thequick disconnect. Connect the pressure transducerquick disconnect to the fusion machine quickdisconnect.PH01169-6-9-97PH01170-6-9-97TX01338-6-12-973 – 1