What is a Smart Drive? - Windenergy

More documents

Recommendations

Info

Manuals/Articles from ecoinnovation.co.nzRemove the cap from the top of the agitator, reach inside and undo the plastic nutthat holds the agitator onto the shaft. Remove the agitator then undo the screws onthe retaining ring.You can now remove the stainless steel bowl from within the plastic outer bowl.Turn the unit over and work from the bottom, remove the magnetic plastic rotor. Itshould look like the picture below.Undo the four fixing screws that hold the copper wire wound stator onto the bearingassembly; you can now cut out the bearing assembly from the plastic bowl with asaber saw. If you don’t have a saber saw you could hire one. The other way wouldbe to use a jig saw to cut the bottom off the plastic bowl and then use a band saw tocut the bearing assembly from this piece. Resist the temptation to use a chain saw;it is not a good idea.The cut bearing assembly should look like this:For more information visit www.ecoinnovation.co.nz 6
Manuals/Articles from ecoinnovation.co.nzThe pictures show the rough cut bearing assembly viewed from both ends, and thenthe same view after the unit has been machined on a lathe. Note that the seal hasbeen removed and the plastic machined down to expose the aluminum fixingchannels. This allows the unit to be fixed to a mounting surface.EcoInnovation removing bearing assembliesRecycling at EcoInnovationRough cut bearing assemblies by the 100’scleaned up and ready to makeinto products.Bearing assembliesdirect from F & PFor more information visit www.ecoinnovation.co.nz 7
Page 1: Manuals/Articles from ecoinnovation
Page 4: Renewable Energy SystemsManuals/Art
Page 9 and 10: Manuals/Articles from ecoinnovation

What is a Smart Drive? - Windenergy

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?