Operating instructions - EWM Hightec Welding GmbH

More documents

Recommendations

Info

Design and functionMIG/MAG welding5.6.2.5 Spool brake settingItem Symbol Description 0Figure 5-101 Allen screwSecuring the wire spool retainer and adjustment of the spool brake• Tighten the Allen screw (8 mm) in the clockwise direction to increase the braking effect.NOTETighten the spool brake until the wire spool no longer turns when the wire feed motor stops butwithout it jamming during operation!5.6.3 Standard MIG/MAG torchThe MIG welding torch trigger is essentially used to start and stop the welding process.Operating elementsFunctionsTorch trigger • Start/stop welding5.6.4 MIG/MAG special-torchesFunction specifications and more indepth information can be found in the operating manual forthe relevant welding torch!34099-005208-EW50110.04.2014
Design and functionMIG/MAG welding5.6.5 Welding task selectionNOTESelection of a welding task involves the interaction of the controls on the weldingmachine and the wire feed unit. After the basic settings are made on the weldingmachine, the operating point and other parameters can be set on the wire feed unit.123025 352040154510503,5 4 5 6 7 8 9 10 111213141532,5162181,5201220,524m/min34Figure 5-115.6.5.1 Accessory components for operating point settingThe operating point setting can also be made with the accessory components• R11 / RG11 remote control• Up/Down torch with two rockers (2 U/D)You will find an overview of accessory components in the "Accessories" chapter. See the operatinginstructions for the machine in question for a more detailed description of the individual machines andtheir functions.099-005208-EW50110.04.201435
Page 1 and 2: Operating instructionsWire feed uni
Page 3 and 4: ContentsNotes on the use of these o
Page 5 and 6: 2 Safety instructions2.1 Notes on t
Page 7 and 8: Safety instructionsGeneral2.3 Gener
Page 9 and 10: Safety instructionsGeneralCAUTIONOb
Page 11 and 12: Safety instructionsTransport and in
Page 13 and 14: Intended useApplications3 Intended
Page 15 and 16: Intended useDocuments which also ap
Page 17 and 18: Machine description - quick overvie
Page 19 and 20: 4.4 Machine control - Operating ele
Page 21 and 22: Design and functionInstallationCAUT
Page 23 and 24: 5.3 Notes on the installation of we
Page 25 and 26: Design and functionConnecting the i
Page 27 and 28: Design and functionShielding gas su
Page 29 and 30: Design and functionMIG/MAG weldingF
Page 31 and 32: Design and functionMIG/MAG welding5
Page 33: Design and functionMIG/MAG weldingI
Page 37 and 38: 6 Maintenance, care and disposalMai
Page 39 and 40: Maintenance, care and disposalDispo
Page 41 and 42: Rectifying faultsError messages (po
Page 43 and 44: Rectifying faultsWelding parameter
Page 45 and 46: Technical dataTaurus Basic drive 20
Page 47 and 48: Replaceable partsWire feed rollers1
Page 49 and 50: Appendix ASetting instructions11 Ap

Operating instructions - EWM Hightec Welding GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?