Stripdown of the HW97K and installation of a venom kit - Cape Air Rifle

More documents

Recommendations

Info

- next remove the front screw (when reinstalling, tighten the back trigger guardscrew at last and don't overtighten).- remove the action from the stock.
- don't loose the small screw at the back of the trigger block, it's kept in placeonly by some grease.- remove the pins which hold the trigger block in the trigger house with a suitabledrift.
Page 1: Stripdown of the HW97K and installa
Page 6 and 7: - after removal of the 2 pins, the
Page 8: - pay attention not to lose that ti
Page 11 and 12: - the anti-bear trap system is set
Page 13 and 14: experience or don't feel comfortabl
Page 15 and 16: - time for a new and better piston
Page 17 and 18: ... and off it goes.- all parts are
Page 19 and 20: - the seal and piston are treated w
Page 21 and 22: - with the spring completely tarred
Page 23: - complete the re-installation and

Stripdown of the HW97K and installation of a venom kit - Cape Air Rifle

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?