RA Balancing propeller shaft - Ad Kusters

More documents

Recommendations

Info

Hold gauge 26 1 030 against front section of propeller shaft andmeasure angle.Determine deflection angle of joint disk,(refer to Technical Data)and, if necessary, correct on transmission suspension or centremount by installing shims (up to max. 3 mm).This requires supporting transmission and unscrewingcrossmember from body.Example:Engine angle 2° 16'Propeller-shaft angle 2° 06'Joint-disk deflection angle 0° 10'Note:When correcting a deflection angle by installing shims,remember that deflection angles of adjacent joints will alsochange.In general, deflection angles of joints should be as small aspossible.RA Balancing propeller shaft BMW AG - TIS 30.09.2003 11:42Issue status (12/2002) Valid only until next CD is issued Copyright Page - 4 -
Place Special Tool 26 1 030 on machined surface of final drive atbottom.Determine deflection angle,refer to Technical Data.Apply Special Tool 26 1 030 on rear section of propeller shaft andmeasure angle.Determine deflection angle of centre mount,(refer to Technical Data)and, if necessary, correct on transmission suspension or centremount by installing shims (up to max. 3 mm).RA Balancing propeller shaft BMW AG - TIS 30.09.2003 11:42Issue status (12/2002) Valid only until next CD is issued Copyright Page - 5 -
Page 1 and 2: 26 11 030 Balancing propeller shaft
Page 3: Move transmission sidewards until s

RA Balancing propeller shaft - Ad Kusters

Create successful ePaper yourself

Delete template?

Save as template?