Owners Manual - Air Compressors Direct

Retain all containers and packing for inspection by the carrier.A claim form can be requested from the carrier: Standard Form for Presentationof Loss and Damage Claims (form # 3208). Your claim will need to besubstantiated with the following documents:a.) form #3208b.) original bill of ladingc.) original paid freight billd.) original invoice or certified copye.) other particulars obtainable in proof of loss or damage (photos,damage inspection, etc.)The proper description and classification of our product in the NationalMotor Freight Classification 100-H, contained in item 118100, reads as follows:Compressors, air, or air ends: with or without air tanks, hose or nozzles,mounted or not mounted.”We suggest that these instructions be circulated to your shipping andreceiving personnel.LocationQT & PLT Series air compressors should be installed in an area that is clean,dry, well lighted, adequately ventilated, and not less than 24 inches to a wallor other compressor. (Note: A gas engine will produce carbon monoxide; alwaysprovide adequate ventilation!) Inspection and maintenance checks are requireddaily. Therefore, sufficient space needs to be provided around thecompressor for safe and proper inspection, cleaning, and maintenance.Ample circulation of air must be provided across the compressor cylinders,heads and cooler (if so equipped). If at all possible, the pulley drive system (i.e.motor pulley, compressor sheave, belts and guard) should be located next to awall to minimize any danger created by the drive system while the compressoris operating. Do not allow hot air from additional equipment to blow towardsthe compressor.QT & PLT series compressors should be operated in temperatures under104°F. In cold climates, the compressor should be installed in a heated building.CAUTION !Do not operate this compressor in ambient temperatures lowerthan -15° F. A crankcase heater is recommended for a compressorthat is to operate in temperatures under 32° F.WARNING !Under no circumstances should a compressor be used in an areathat may be exposed to toxic, volatile, or corrosive atmosphere. Donot store toxic, volatile, or corrosive agents near the compressor.NoiseNoise is a potential health hazard that must be considered. There are federaland local laws governing acceptable noise levels. Check with local officials forspecifications.QT & PLT SeriesQuincy Compressor50161-106, January 2009 7 3501 Wismann Lane, Quincy Ill. - 62305-3116