Pit Jacks, Support Systems and Accessories - Tecalemit AS

Pit JacksAdaption Jack Carriage for existing Working PitsSelection CriteriaWhen selecting the jack carriage, pay attention to theexisting pit protrusion.Pay close attention to any lighting that is installed inthe pit when using hanging carriages.FlexibleBy moving the side plates,the jack carriage is adjustedto the pit dimensions.Serial rollers have a slightangle and fi t most profi les.The serial rollers must be adaptedfor profi les with pronounced angle.(optional).The adjustment range iscalculated in steps so thatthe jack installation canbe done in a closed pitprofi le U 220. Only weldedcarriages are supplied witha load capacity of 15 t ormore. Custom made carriagesare offered for lowerload capacities.Protruding cement, lamps or linesetc. require that elongated rollers beused (optional).Our pit jacks are made to fit your pit dimensions. Pleasemake use of our dimension sheet when placing your order!S-CarriageWith this carriage, the upper end of the retracted piston rodis at the same level as the jack‘s total height. This meansjacks with low lift can be used.P-CarriageProfessional use of support bridges with axle traverses in thisversion. The smooth, deeply drawn carriage side plates meansaxle traverses and other platforms can be moved underneaththe support bridges.Our jack systems are designedfor a pit edge width upto 1.080 mm. Special solutionsare possible. (optional).8