Sams 70-7 - Early Television Foundation

ITEMNo.L14L15LieL17LIBL19L20L21L22L23L24L25L26L27L28129ISOITEMNo.MlM2M3M4TEMNo.MSM6M7MSM9moUSEPeakingPeakingPeakingSound IFDisc. TransWidth Cont.Hor. LinearityFM Ant.FM Osc.AM Ant.AM Osc.FM 1st IFAM 1st IFFM 2nd IFAM 2nd IFRatio Det.Trans .Fll. Chk.PARTS LIST AND DESCRIPTIONS (Continued)BASE TYPEBayonetBayonetBayonetBayonetPRI.4.5S22.2S4.52OfflOffl02362OfflOffl26ffl4ffl.521221.2982.12OfflPART NAMEBand SwitchTone SwitchFuseTuning CapIon TrapTunerSafety GlassDial ScaleDial ScaleKnobKnobKnobKnobKnobKnobKnobKnobKnobDC RES.020202SEC.1.52.82122.5282,12VOLTS7.57.57.57.5AMPS..2.2.2.2COILS CRF-IF)CONT.REPLACEMENT DATARCAPART No.7152971793715297142471427714397144972335723367207172333728877162572888716317288972574BEADCOLORWhiteWhiteWhiteWhiteRCAPART No.72852716037205971792KRK2B-1730277307072682718217280071533715347153571536725657256672567MEISSNERPART No.14-106016-665816-6660DIAL LIGHTSREPLACEMENT DATAROAPART No.11765117651176511765MISCELLANEOUS iIncludes TV Power SwitchNot used in all sets26-568MMF, 13-368MMF W/TElecto-MagnetNOTES120 Microhenries. Wound on 22K2 resistor.36 Microhenries.120 MicrohenriesIncludes 10MMF capacitor and 33MMF cap.Includes 2-56MMF capacitor and 47MMF cap.Type #51Type *51Type 151Type #51NOTESNOTESFor model 730TV1For model 730TV2For radio tuning, band switch, off-volume, and toneswitch for walnut or mahongany Instruments.For radio tuning, band switch, off-volume and toneswitch for toasted mahogany instruments.For fine tuning for walnut or mahogany instruments.For station selector for walnut or mahoganyinstruments .For brightness and vertical hold for walnut ormahogany instruments .For contrast or horizontal hold for walnut or mahoganyInstruments.For brightness and vertical hold for toasted mahoganyinstruments .For contrast and Hor. hold for toasted mahoganyinstruments .For fine tuning for toasted mahogany instruments.DISASSEMBLY INSTRUCTIONS1. Remove 3 push-on type knobs from TV controls.2. Remove 4 push-on type knobs from receiver controls.3. Remove 9 screws holding rear cover.4. Remove picture tube base socket and Ion trap.5. Remove HV cap from picture tube.6. Remove 2 phlllips-head screws from upper corners of picture tube front plate. Remove front plate.7. Loosen 4 screws holding clamps at large end of picture tube. Remove tube, slide forward.8. Remove TV power plug from rear of receiver chassis.9. Remove TV audio plug from rear of receiver chassis.10. Remove TV antenna plug from rear of receiver chassis.11. Remove 7 hex head bolts holding TV chassis.12. Remove TV chassis.13. Remove speaker plug at speaker.14. Remove phono audio plug from rear of receiver chassis.15. Remove receiver antenna plug from rear of receiver chassis.16. Disconnect phono power plug.17. Remove panel lamp from Inside bottom front center of cabinet.18. Remove panel lamp from phono section.19. Remove two hex head bolts from rear of receiver mounting board.20. Remove two hex nuts holding receiver chassis to mounting board. Remove hooked studs by pushing up and turn21. Remove receiver chassis.22. Remove four hex nuts holding speaker.23. Remove speaker.PAGE 16