COMPRESSOR TOOLSHERMETI-CHECKHermetic compressors are permanently sealed which means there is little you can do to fix one that is broken onthe inside. However with the following tools brought to you by Imperial-Thermal Engineering, you can test thecompressor for any electrical problems it may have which can help determine the appropriate actions to take.HERMETI-CHECK2001Hermeti-Check tests all single phase compressors up to 5 HP, 110, 220 or 277 volts.Features• Tied-up compressors may be freed by reversing motor rotations.• Tests windings for opens, continuity, and grounds.• Tests start and run capacitors and system relays by substitution.• Measures running amps, 0-10, 50A range.• Measures start and run volts, 0-150, 600V AC ranges.• Compressors are tested in the manner in which they were designed to operate:split-phase, capacitor start, or PSC.• Has provisions for connecting external run capacitor. (1) 30A breaker protected toallow high starting current with adequate overload protection.• Complete with 220V adapter cord and capacitor leads.WEIGHT POWER DIMENSIONS3 LBS 110, 220, OR 277 VAC 50/60 HZ 12-1/8” x 8” x 3-3/8”PROFESSIONAL SERIES DIGITAL HERMETIC ANALYZER12501AFeatures• Easy to read digital LCD display.• Tests and runs 110, 220 or 277 volt 50/60 Hz single phase compressors up to 5 HP.• Tied-up compressors may be freed by reversing motor rotation.• Tests windings for opens, continuity, and grounds.• Checks capacitors for leaks, opens, and shorts.• Measures capacitor values, 0-200, 0-2000 MFD ranges.• Automatic capacitor discharge.• Measures compressor amps, 0-30A.• Measures start and run volts, 0-600VAC.• Measures winding resistance, 0-2000 ohm.• 500V megger for testing compressor windings for grounds.• Compressors are tested in the manner in which they were designed to operate:split-phase, capacitor start, or PSC.• Multiple internal starting capacitors: 100, 200 and 400 MFD values.• Has provisions for connecting external run capacitor.• 30A breaker protected.• Complete with 220V adapter leads and capacitor leads.Upgraded Features• Combined run and start information onto single screen.• Each screen describes what it is measuring.• New safety features prevent switching from high voltage to low voltage measurementuntil charge has dissipated.• Compressor cannot be started unless selector switch is in a run mode.Rememberthe2001Back byPopular Demand12501AWEIGHT POWER DIMENSIONS9.5 LBS 110, 220, OR 277 VAC 50/60 HZ 15-1/2” x 13-3/8” x 6”69
COMPRESSOR TOOLSACCESSORIESA compressor may just have a bad electrical part. These accessories will help determine exactly what is going on.QUIK-START2601Quik-Start starts all single phase compressors up to 5 HP 110, 200, 277V AC. A troubleshootingaid for determining whether fault lies with compressor or component parts.Fusetron protects against shorts and overloads, but allows high starting load. Capacitorleads provide means of starting split phase, capacitor start, or permanent split capacitorcompressors.TEST LEAD KIT2605Test Lead Kit consists of 4 leads 30” long with insulated test clips in each end fortemporarily connecting relays, capacitors, etc., into a system for test purposes and hasa 6ft. heavy duty power cord with a male pIug on one end and insulated test clips onthe other. Also has a 12” power cord with a female socket on one end and insulated clipson the other.26012605QUIK-START + TEST LEAD KIT COMBO2602Combination of Model 2601 Quik-Start and Model 2605 Test Lead Kit.ADAPTER CORD2136Provides a 12” 3-wire grounded power cord with standard female plug on one end andinsulated clips on the other end. This cord is supplied as standard equipment with Models2001, 2605, and 12501A.COMPRESSOR TERMINAL REPAIR KITGL-1000The GL-1000 Gator-Lok is designed to repair burnt terminals on compressors up to 5 tons.Gator-Lok’s unique design makes installation a snap and requires no special tools.Gator-Lok is made from high quality materials. Once installed properly, it provides multiplepoints of contact on the burnt terminal.Gator-Lok can be easily installed in minutes, therefore giving the technician the ability torestore power to the unit, and eliminates the need to replace the compressor.Each Gator-Lok Kit includes a set of three Gator-Loks (1 red, 1 blue and 1 black 10 gaugewire with 30” leads).GL-100070